CDI CD42-T1A User Manual page 30

GETTING STARTED CD42 T3
Installing Ba ery
L L L L L L L L L o L L L Load single CR-123 ba ery, L L L L L L ad single CR-123 ba ery,
posi ve (+) end fi rst. p posi ve (+) end fi rst.
NOTE: it is good prac ce to always install a new ba ery NOTE: it is good prac ce to always install a new ba ery NOTE: it is good prac ce to always install a new ba ery
prior to deployment. prior to deployment.
Inspect cap and O-ring before replacing.
Ensure O-ring is serviceable. A bri le and/or deformed O-ring may not
properly seal. Lubricate O-ring with a light coa ng of petroleum jelly
if dry.
Ensure threads are clean and free of ruptures, dents, and other damage.
Replace cap. Your CD42-T3 is now ac ve.
NOTE: T-Series Transmi ers have no "ON-
OFF" switch. Unless your transmi er is
factory-confi gured for Delay On opera on,
it will begin opera on when cap is installed.
Placing Into Service
See pg. 34
22 Hz ELECTROMAGNETIC TRANSMITTER USER GUIDE
Page 30 of 52