HP ProLiant SL165s G7 Maintenance And Service Manual page 38

Figure 10 Processor locations
Item
1
2
WARNING: To reduce the risk of personal injury from hot surfaces, allow the heat sink and the
processor to cool before touching them.
To remove the heat sink:
CAUTION: To prevent the heat sink from tilting to one side during installation and removal procedures, use a
diagonally opposite pattern (an "X" pattern) when loosening and tightening the two spring-loaded screws. Do
not over tighten the heat sink's spring-loaded screws to prevent them from breaking off. A maximum torque of
4 in-Ib is set for the system.
Loosen the two mounting pins.
1.
Lift the heat sink away from the system board.
2.
Lift the heat sink frame away from the system board.
3.
CAUTION: Place heat sink down in an upright position with the thermal patch facing upward. Do
not let the thermal patch touch the work surface.
Description
Processor 1
Processor 2
Removal and Replacement Procedures 38