Demonstration Mode; Switching The System On; Switching The System To Standby Mode; Dim Mode - Philips FW M355 User Manual

Demonstration mode

The system has a demonstration mode that
shows the various features offered by the system.
To activate the demonstration
In standby mode, press and holdÇon the
system until "WELCOME" is displayed.
The demonstration will begin.
To deactivate the demonstration
Press and holdÇon the system until
"DEMO OFF" is displayed.
The system will switch to standby mode.
Note:
– If you have not deactivated the demonstration, it
will resume five seconds after the system switches
to standby mode.

Switching the system on

In standby/demonstration mode
Press STANDBY ON to switch on the last
selected source.
Press CD 1/2/3, TUNER, TAPE (TAPE 1/2),
or AUX.
Press OPEN/CLOSE.
The system will switch to CD mode.
Switching the system to standby
mode
In demonstration mode
Press and hold Ç on the system.
In any other source mode
Press STANDBY ON (or B on the remote
control).
The clock will appear on the display when the
system is in standby mode.
pg 001-031/M355/37-Eng

Dim mode

You can select the desired brightness for the
display.
In any source mode (except standby mode),
press DIM repeatedly to select DIM 1, DIM 2,
DIM 3 or DIM OFF display mode.
DIM
Note:
– In standby mode, pressing DIM to select half or
full brightness for clock display.

Volume control

Adjust MASTER VOLUME (or press
VOLUME + or - on the remote control) to
increase or decrease the volume level.
To listen through the headphones
Connect the headphones plug to
the n socket at the front of the
system.
The speakers will be muted.
To switch off the volume temporarily
Press MUTE on the remote control.
Playback will continue without sound and
"MUTE" is displayed.
To restore the volume, press MUTE again or
increase the volume level.
15
Basic Functions
is shown, except for DIM OFF mode.
Spectrum
DIM Brightness
mode Analyzer
1
normal off
2
half on
3
half off
OFF
normal on
3139 115 21402
4/17/02, 12:54 PM
15