Table of Contents
Advertisement
The "30" tilt tab indicator starts flashing and after few seconds the
instrument leaves the function mode.
Now you can unplug the USB Memory safely.
Installing Music Rest
Install the included music rest as shown in the illustration below.
Installing the USB LED Lamp
The ONE is equipped with a 5 Volt POWER PORT. When the light is not
enough to read music, you can connect the flexible LED lamp.
POWER PORT
BALANCE
5 VOLT
1.
Connect the flexible LED lamp to the POWER PORT.
NOTE
MAN I
MAN II
Carefully insert the LED lamp making sure that the connector on
PEDAL
the device is appropriate and that it is connected in the proper
direction.
VOLUME
WARNING
Do not connect any other devices to this power port. An
excessive current consumption can damage the instrument.
Ground Terminal
Depending on the circumstances of a particular setup, you could feel a
tingling sensation at the point where you touch this device.
You can eliminate this sensation connecting the ground terminal with an
external ground.
THE ONE REAR SIDE
1.
Use the screw-type ground terminal to connect to ground
or to connect to the chassis of the mixer, preamp, or other
device in your system.
Turning the Power On
Once everything is properly connected, be sure to follow the procedure
below to turn on their power.
1.
Rotate the [VOLUME] knob toward the left position to
minimize the volume.
NOTE
Before turning the ONE on/off, always be sure to turn the
volume down. Even with the volume turned down, you might
hear some sound when switching the ONE on/off.
However, this is normal and does not indicate a malfunction.
2.
Press the ONE's [
] button located on the right panel to
"
switch it on.
The power will turn on, the tilt tab indicators light in sequence.
After a brief interval, the ONE will be ready to produce sound.
3.
Use the [VOLUME] knob to adjust the volume.
NOTE
This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
Turning the Power Off
1.
Rotate the [VOLUME] knob toward the left position to
minimize the volume.
NOTE
To avoid malfunctions, never disconnect the AC/DC adapter
while the instrument is turned on.
2.
Press and hold the ONE's [
All indicators go dark and the LED meter of TRANSPOSE flashes to
indicate that the unit will turn off after few seconds.
Installing Music Rest
DC IN
OUTPUT
USE DEXIBELL
R
L/MONO
DYS602-240250W
ADAPTOR ONLY
24 Vdc
BALANCE
MAN I
MAN II
PEDAL
VOLUME
] switch for a few seconds.
"
POWER P
5 VOLT
19
Hide quick links:
Advertisement
Table of Contents
