Table of Contents
Advertisement
General
Specifications
The JET 5x8 cutoff bandsaw is available as
a dry cutting bandsaw or as a wet cutting
bandsaw. If required, a dry cutting bandsaw can
be retrofitted with a kit which converts it to use
with cutting fluids.
The use of a hydraulic feed delivers
consistent accurate cuts and longer blade life.
Model
Stock Number
J-3130
414461
J-3230
414453
Cutting capacity
4
Speeds
Blade drive
Saw guides
Motor
Blade wheels
Saw blades
Floor model dimensions
Optional wet cutting pkg.
5 inch (127mm) round
7 1/2 inch (190.5mm) wide x 5 inch (127mm) high rectangle
8 inch (203.5mm) wide x 1 inch (25.4mm) high flat stock
4 1/2 inch (114.3mm) wide x 5 inch (127mm) high at 45 degrees
85,125,200 SFM
Steel, heat treated worm driving a bronze worm gear in an oil bath
Ball bearing mounts on an eccentric shaft, ball bearing rear guide
bearings -- all bearings sealed and permanently lubricated
1/2 HP, 115/230V, 1725RPM capacitor start
7-3/8 inch (187mm) diameter flanged cast iron
1/2 x .025 x 68 inches
Width 16 inches overall (400mm)
Height 38 inches overall with arm horizontal (950mm)
Height 58 inches overall with arm vertical (1450mm)
Length - 38 inches (950mm)
1 gallon (4.5L) capacity tank, pump motor: single phase 120V
Advertisement
Table of Contents
