Panasonic CF-18 Series Reference Manual page 77

Dealing with Problems
Connecting Peripherals
An error occurs while in-
stalling the driver
Your peripheral does not
work
Unable to print
The cursor does not
move from mouse opera-
tions
External mouse or track-
ball connected to the ex-
ternal keyboard/mouse
port of the port replicator
does not work
A PC Card does not work
USB floppy disk drives
do not work as a boot
drive
You do not know the
available RAM module
Cannot tell whether the
RAM module has been
correctly installed
The RAM module has not
been recognized
When you install the driver for a PC Card or peripheral device, be sure to use a driver
that is compatible with the operating system. If you use an incompatible driver, mal-
function may occur. For information on drivers, contact the manufacturer of the pe-
ripheral device you purchased.
When operation resumes from the standby or hibernation mode, serial devices such
as a mouse, modem or PC Cards may not function properly. In such cases, you will
need to restart your computer or reinitialize the individual devices.
Make sure the printer is on.
Make sure the printer is in the online state.
Make sure paper is in the printer tray and there is no paper jam.
Check your mouse connection, then restart the computer by using the keyboard.
Windows 2000
From the keyboard, you may choose to press down on
Windows XP
From the keyboard, you may choose to press down on
Computer].
A driver which is compatible with the connected mouse must be installed.
If the device does not operate when the driver is installed:
In the Setup Utility, set [Touch Pad] to [Disable].
Try setting [Touch Pad] to disable in the Setup Utility.
In some circumstances, if a PS/2 external mouse with a serial interface conversion
function is connected to the port, it may not operate normally. Try connecting it to
the serial port.
Make sure the card is properly inserted.
Confirm that the card conforms to the PC Card Standard.
Note that after a driver (PC Card driver on other) is installed, the computer must be
restart.
Check that the proper port settings have been made.
Read the operating instructions for the PC Card. Or, you may need to call the
manufacturer of the PC Card.
Try removing/reinser ting the PC Card by following the proper procedure.
( page 43)
Confirm that a driver for your operating system has been installed.
Only the Panasonic CF-VFDU03 USB floppy disk drive can be used.
Do not connect the floppy disk drive to the USB connector of the port replicator for
this computer.
Make sure [Legacy USB Suppor t] is enable in the Setup Utility.
After powering off the computer, connect the USB floppy disk drive and restart the
computer.
page 45
You can check whether the RAM module is recognized using [Information] menu in
the Setup Utility. If the RAM module is not recognized, turn the computer off and
reinsert the RAM module.
Make sure the RAM module has been properly inserted.
Use the RAM module that supports the recommended specifications (
(Advanced)
, then select [Shut Down].
, then select [Turn Off
page 45).
77