Panasonic CF-18 Series Reference Manual page 56

Hide thumbs Also See for CF-18 Series:
Table of Contents

Advertisement

LAN
Wake up from LAN
This is a function of the internal LAN to automatically power the computer on from a
network server when the computer is in the standby or hibernation mode. To use this
function, it is necessary to have a network environment that accommodates Wake up
from LAN.
Enabling the Wake up from LAN Function
Windows 2000
1
Select [Device Manager] in [Start] - [Settings] - [Control Panel] - [System] - [Hard-
ware].
2
Select the network adaptor name you are using from [Network adapters].
3
Select [Power Management], add the check mark for [Allow this device to bring the
computer out of standby.] and [Allow the computer to turn off this device to save
power.], then select [OK].
4
Remove the check mark from [Prompt for password when computer goes off
standby] in [Control Panel] - [Power Options] - [Advanced], then select [OK].
Windows XP
1
Select [Device Manager] in [Start] - [Control Panel] - [Performance and Mainte
nance] - [System] - [Hardware].
2
Select the network adaptor name you are using from [Network adapters].
3
Select [Power Management], add the check mark for [Allow the computer to turn
off this device to save power] and [Allow this device to bring the computer out of
standby], then select [OK].
4
Remove the check mark from [Prompt for password when computer resumes from
standby] in [Control Panel] - [Performance and Maintenance] - [Power Options] -
[Advanced], then select [OK].
NOTE
Be sure to connect the AC adaptor, and enable the supply of power.
Even when a password is set in the Setup Utility and [Password on boot] is set to
[Enable], it is not necessary to input the password set in the Setup Utility when
the computer resumes from standby or hibernation mode.
The Wake up from LAN function will not operate under the following conditions:
• When the computer has been shut down
• When the power switch is slid over for four seconds or longer to turn off the
power (e.g., when the computer hangs)
• When the AC adaptor and battery pack are removed from the computer or
reattached to the computer
• When the LAN cable is disconnected and reconnected
Make settings to allow the use of a LAN.
After operations are resumed from standby status, the screen remains dark. The
former screen display will be restored when the keyboard, touch pad or touch-
screen is used.
The computer may start up if accessed by another computer on the network.
Windows XP
The following procedure can be used to prevent startup due to unintentional ac-
cess by a computer.
1
Select [Start] - [Control Panel] - [Performance and Maintenance] - [System] -
[Hardware] - [Device Manager] - [Network adapters], then select the network
adaptor name you are using, and then select [Power Management].
2
Add the check mark for [Only allow management stations to bring the computer
out of standby], then select [OK].
56

Advertisement

Table of Contents
loading

Table of Contents