How To Configure The Ifr 2968 Manual Test Screen - Motorola MTP700 Basic Service Manual

TEST SETUP & TESTING
29. Press "Signal Type" soft key and "Direct set –up" soft key.
30. Press "Priority" soft key. Thereafter, enter "00" and press the "Priority" soft key.
31. Leave "Calling Party SSI" setting to default value.
32. Press "Return" soft key.
33. Leave "Messages" setting to default value.
34. This completes the System Setup configuration.

How to Configure the IFR 2968 Manual Test Screen

Note: Terms for 380-430 MHz radio in brackets [ ].
1. To enter Manual test screen, press "Manual" soft key.
2. Press "Control Channel" soft key. Thereafter, enter "2440" ["800"] and press "Control
3. Press "Traffic Channel" soft key. Enter "2140" ["800"] and press "Traffic Channel" soft
4. Press "RF Gen Level" soft key and enter "-50". Then press the "dBm" or "RF Gen
5. Press "Mobile Power" soft key followed by the appropriate "5dB step" soft key until
6. Press "Burst Type" soft key and "Normal" soft key. Then press "Return" soft key.
7. This completes the Manual test equipment configuration setup.
Note: The System Setup Configuration Data is saved even after the power is turned off.
MTP700/MTP750 Portable Radios / Basic Service Manual
Channel" soft key (where IFR "2440" = Rx 861.0125MHz) [IFR "800" = Rx
420.0125MHz].
key. The marker goes to Timeslot. Enter "3" and press "Traffic Channel" soft key.
(Note that the Traffic Channel number changes automatically after entering the Con-
trol Channel number).
Level" soft key.
"30 dBm/1W" is obtained. Then press "Return" soft key.
However, the Manual Test Setup is not saved.
5-7