Motorola MTP700 Basic Service Manual page 36

4 - 6
10. Press any key again. The display shows "Speaker Tone Test", a tone is heard via the
11. Press any key again. The display shows "Earpiece Tone Test", a tone is heard via
12. Press any key again. The display shows "Audio Loopback Test", speak into the
13. Press any key again. The display shows "Chopper-Noise Test 1", a low hum must not
14. Press any key again. The display shows "Chopper-Noise Test 2", a low hum must not
15. Press any key again. The display shows the "Rotary Knob Test" map.
16. Rotate the talkgroup knob from location "1" until "16" and make sure at each location
17. The display proceeds to show all the radio keys, knobs and buttons.
18. Press every radio item one by one. Each item you press causes its respective display
19. The display then shows "Press any key to Continue".
20. Pressing any key will cause display to show a series of "*", "<" and ">" characters.
21. Press the Top Navigation key until all top four "*" characters disappear.
22. Press the Bottom Navigation key until all bottom four "*" characters disappear.
23. Press the Left Navigation key until all left four "<" characters disappear.
24. Press the Right Navigation key until all right four ">" characters disappear.
25. After pressing all keys, the display is clear.
26. Turn the radio Off.
MTP700/MTP750 Portable Radios /Basic Service Manual
speaker.
the earpiece.
microphone, you should hear your voice via the earpiece.
be heard via the earpiece.
be heard via the earpiece.
the corresponding number disappears from the display.
to disappear.
PROGRAMMING THE RADIO