NETGEAR FWG114P Reference Manual page 80

Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
This screen shows the following parameters:
Table 7-1. Menu 3.2 - FWG114P Status Fields
Field
System Name
Firmware Version
WAN Port
MAC Address
IP Address
IP Subnet Mask
DHCP
LAN Port
MAC Address
IP Address
IP Subnet Mask
DHCP
IEEE802.11a/b/g Interface
SSID
MAC Address
Channel/Frequency
WEP Status
7-2
Description
This field displays the System Name assigned to the router.
This field displays the router firmware version.
These parameters apply to the Internet (WAN) port of the router.
This field displays the MAC address being used by the Internet (WAN)
port of the router.
This field displays the IP address being used by the Internet (WAN) port
of the router. If no address is shown, the router cannot connect to the
Internet.
This field displays the IP Subnet Mask being used by the Internet (WAN)
port of the router.
This field shows the protocol on the WAN port used to obtain the WAN
IP address. This field can show DHCP Client, Fixed IP, PPPoE, BPA or
PPTP. For example, if set to Client, the router is configured to obtain an
IP address dynamically from the ISP.
These parameters apply to the Local (WAN) port of the router.
This field displays the Media Access Control address being used by the
LAN port of the router.
This field displays the IP address being used by the Local (LAN) port of
the router. The default is 192.168.0.1
This field displays the IP Subnet Mask being used by the Local (LAN)
port of the router. The default is 255.255.255.0
Identifies if the router's built-in DHCP server is active for the LAN
attached devices.
These parameters apply to the 802.11a Wireless port of the router.
This field displays the wireless network name (SSID) being used by the
wireless port of the router. The default is Wireless.
This field displays the MAC address being used by the wireless port of
the router.
Identifies if the channel the wireless port is using. See
Channels" on page D-7
Identifies the current WEP configuration of this interface.
M-10177-01
for the frequencies used on each channel.
"Wireless
Maintenance