SiENBE12-620
To 3-D Airflow
1.3. Press the "SWING button
To cancel 3-D Airflow
2.4. Press either the "SWING button
Notes on louvers angles
ATTENTION
•
Always use a remote control to adjust the louvers angles. In side the air outlet, a fan is rotating at a high speed.
Notes on flap angles
When "SWING button" is selected, the flaps swinging range depends on the
•
operation mode. (See the figure.)
Three-Dimensional (3-D) Airflow
•
Using three-dimensional airflow circulates cold air, which tends to collected at
the bottom of the room, and hot air, which tends to collect near the ceiling,
throughout the room, preventing areas of cold and hot developing.
ATTENTION
•
Always use a remote control to adjust the flaps angle. If you attempt to move it
forcibly with hand when it is swinging, the mechanism may be broken.
•
Be careful when adjusting the louvers. Inside the air outlet, fan is rotating at a
high speed.
System Configuration
display will light up and the flap and louvers will move in turn.
" and the "SWING button
" or the "SWING button
approx. 10°~40°
approx. 5°~35°
approx. 15°~55°
approx. 5°~55°
Instruction
":the "
" and "
".
In COOL or DRY mode
STOP
COOL
DRY
In HEAT or FAN mode
STOP
HEAT
FAN
"
145