Daikin E-Series Service Manual page 162

SiBE12-818
Outdoor Unit
20/25/35/42 class
17
21
Indoor Unit
1. Air filter
2. Titanium Apatite Photocatalytic
Air-Purifying Filter:
• These filters are attached to the inside of
the air filters.
3. Air inlet
4. Front panel
5. Panel tab
6. Room temperature sensor:
• It senses the air temperature around the
unit.
7. INTELLIGENT EYE sensor
8. Display
9. Air outlet
10. Horizontal blades (flaps)
11. Vertical blades (louvers):
• The louvers are inside of the air outlet.
Outdoor Unit
17. Air inlet: (Back and side)
18. Refrigerant piping and inter-unit cable
19. Drain hose
Operation Manual
50 class
17
18
19
21
20
12. Indoor Unit ON/OFF switch:
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refers to the following
table.
Model
COOLING
ONLY
HEAT
PUMP
• This switch is useful when the remote
controller is missing.
13. Operation lamp (green)
14. TIMER lamp (yellow)
15. INTELLIGENT EYE lamp (green)
16. Signal receiver:
• It receives signals from the remote controller.
• When the unit receives a signal, you will
hear a short beep.
• Operation start ........ beep-beep
• Settings changed ..... beep
• Operation stop.......... beeeeep
20. Earth terminal:
• It is inside of this cover.
21. Air outlet
18
19
20
Temperature Airflow
Mode
setting rate
COOL 22˚C AUTO
AUTO 25˚C AUTO
Instruction
151