Engine Controls - Jacobsen 32251 Technical Manual

6 CONTROLS
6.2

ENGINE CONTROLS _______________________________________________________

6.2.4
6.2.1
6.2.2
6.2.7
6.2.4
6.2.1
6.2.1 FUEL SHUT-OFF VALVE ____________________________________________________
Rotate the fuel shut off valve 90°to the CLOSED position to stop the flow of fuel to
the carburetor. The fuel valve must be in the OPEN position for the engine to
operate.
When the mower is not used or before you service the mower, close the fuel shut-off
valve.
6.2.2 STARTER HANDLE ________________________________________________________
The starter handle is used to start the engine. Slowly pull on handle until resistance is felt, then pull firmly. Do not allow
the starter handle to snap back into the recoil starter.
6.2.3 DIPSTICK/OIL CAP ________________________________________________________
The dipstick/oil cap is used to check the engine crankcase oil level and add oil to the engine.
6.2.4 AIR FILTER COVER________________________________________________________
The air filter cover holds the air filter in position to prevent dirt and debris being pulled into the engine.
6.2.5 FUEL TANK CAP __________________________________________________________
Remove the fuel tank cap to add fuel to the mower. When the engine operates, do not remove the fuel tank cap. Do not
start the engine unless the fuel cap is installed.
en-17
6.2.2
6.2.5
6.2.5
20 inch
HoverKing
Engine
6.2.3
6.2.6
16 inch
HoverKing
Engine
6.2.3
OPEN
Position
CLOSED
Position