Controls 6; Handle Controls - Jacobsen 32251 Technical Manual

6Controls
6.1

HANDLE CONTROLS_______________________________________________________

6.1.2
6.1.1 BAIL HANDLE ____________________________________________________________
The bail handle controls the operation of the OPC (Operator Presence Control) system. The bail handle must be closed
before the engine will start. When the bail handle is released, the engine must stop within 3 seconds.
6.1.2 THROTTLE LEVER (20 INCH (50.8 CM) HOVERKING ONLY) _______________________
The throttle lever is to control the engine speed. Push the throttle lever forward to increase the engine speed. Pull the
throttle lever to decrease the engine speed. When you operate the mower, Jacobsen recommends that the engine
speed is at full throttle.
When you start a cold engine, pull the throttle lever completely toward the operator to close the choke plate. Slowly
push the throttle lever forward to increase the engine speed as the engine becomes warm.
20 inch
HoverKing
Handle
6.1.1

CONTROLS 6

16 inch
HoverKing
Handle
6.1.1
en-16