Table of Contents
Advertisement
This manual is property of the owner. Leave with the collector when set-up and start-up are complete. Donaldson Company reserves the
right to change design and specifications without prior notice.
Illustrations are for reference only as actual product may vary.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible injury or death.
English
Master Language
Centrifugal Mist Collector
E-100, E-200, E-300, E-500
EA-700, EA-900, and EA-905
Installation and Operation Manual
Installation, Operation, and Service Information
IOM 1B0510107 (ENG)
Revision 3
Advertisement
Table of Contents
Related Manuals for Donaldson Torit E-100
Summary of Contents for Donaldson Torit E-100
- Page 1 Centrifugal Mist Collector E-100, E-200, E-300, E-500 EA-700, EA-900, and EA-905 Installation and Operation Manual Installation, Operation, and Service Information This manual is property of the owner. Leave with the collector when set-up and start-up are complete. Donaldson Company reserves the right to change design and specifications without prior notice.
- Page 2 Installation and Operations Manual. For a replacement manual, contact Donaldson Torit. This manual contains specific precautionary statements relative to worker safety. Read thoroughly and comply as directed. Discuss the use and application of this equipment with a Donaldson Torit representative. Instruct all personnel on safe use and maintenance procedures.
-
Page 3: Table Of Contents
Centrifugal Mist Collector, E-100 to EA-905 Contents Preliminary Start-Up Check ...........8 Description ................1 Maintenance Information ............9 Purpose and Intended Use ............1 Operational Checklist ............9 Operation ...................2 Disposable Filter Liner Replacement ........9 Inspection on Arrival ...............3 Primary Filter Replacement ..........9 Installation Codes and Procedures ........3 Secondary Filter Replacement ...........9... -
Page 4: Description
Consult and comply with all National and Local Codes related to fire and/or explosion properties of combustible materials when determining the location and operation of all dust, fume, or mist collection equipment. Standard Donaldson Torit equipment is not equipped with fire extinguishing or explosion protection systems. -
Page 5: Operation
Centrifugal Mist Collector, E-100 to EA-905 Operation During normal operation, mist-laden air enters the oil along the housing walls, through a circumferential collector through a flexible hose. The air passes through slot, and into a collection chamber where the liquid is a disposable first-stage filter and into a second-stage drained. -
Page 6: Inspection On Arrival
Turn power off and lock out electrical 6. Report incomplete shipments to the delivery carrier power sources before performing service or and your Donaldson Torit representative. maintenance work. 7. Remove crates and shipping straps. Remove loose Do not install in classified hazardous... -
Page 7: Collector Location
Centrifugal Mist Collector, E-100 to EA-905 Collector Location Hoisting Information Donaldson Torit equipment is not Failure to lift the collector designed to support site installed correctly can result in severe ducts, interconnecting piping, or electrical personal injury and/or property damage. -
Page 8: Electrical Wiring
Donaldson Company, Inc. Electrical Wiring Standard Equipment Electrical installation, service, The Centrifugal Mist Collector is normally installed or maintenance work must horizontally; however, it can be installed vertically with be performed by a qualified electrician and the inlet end down. comply with all applicable national and local 1. -
Page 9: Drain Connection
1. Use 1-in diameter pipe or flexible hose for the drain and connects the same way the primary drain connects. connection. 2. Models E-100 and E-200 are equipped with a Do not submerge ends of hose. Do 1-in NPT male drain fitting and Models E-300 through... -
Page 10: Electrical Connection
Donaldson Company, Inc. Electrical Connection Electrical installation must be performed by a qualified electrician and comply with all applicable national and local codes. Lock out electrical power sources before performing service or maintenance work. Do not install in classified hazardous atmospheres without an enclosure rated for the application. -
Page 11: Preliminary Start-Up Check
Centrifugal Mist Collector, E-100 to EA-905 Preliminary Start-Up Check Instruct all personnel on safe use and maintenance 5. Check that all optional accessories are installed procedures. properly and secured. Electrical work during 6. Turn power ON at source. installation, service or 7. -
Page 12: Maintenance Information
Donaldson Company, Inc. Maintenance Information Disposable Filter Liner Replacement Turn unit OFF and check that drum Instruct all personnel on safe use and maintenance has stopped before removing the procedures. cover. Use proper equipment and adopt 1. Using a felt tip marker or scribe, mark the location of all safety precautions needed for the liner ends on the face of the drum. -
Page 13: Optional Equipment
Centrifugal Mist Collector, E-100 to EA-905 Optional Equipment Prefilter Trap In-Cover Trap o-ring filter retainer wing nut lock washer flat washer hex nut in-cover trap v-ring Prefilter Trap 1/2-in flexible tube In-Cover Trap... -
Page 14: In-Cover Impinger
Donaldson Company, Inc. In-Cover Impinger O-ring hex nut impinger lock washer in-cover housing V-ring 1/2 x 1/2 x 1/2-in barbed nylon tee 1/2-in flexible tube In-Cover Impinger... -
Page 15: Hepa Filter
Centrifugal Mist Collector, E-100 to EA-905 HEPA Filter cover HEPA filter HEPA filter housing #10 x 1-in self-tapping screw silicone sealant HEPA Filter... -
Page 16: Troubleshooting
Donaldson Company, Inc. Troubleshooting Problem Probable Cause Remedy Collector will not start Improper motor wire size Rewire using the correct wire gauge as specified by national and local codes. Not wired correctly Check and correct motor wiring for supply voltage. See motor manufacturer's wiring diagram. -
Page 17: Service Notes
Centrifugal Mist Collector, E-100 to EA-905 Service Notes Date Service Performed Notes... - Page 18 Donaldson Company, Inc. Service Notes Date Service Performed Notes...
- Page 20 The Donaldson Torit Warranty Donaldson warrants to the original purchaser that the major structural components of the goods will be free from defects in materials and workmanship for ten (10) years from the date of shipment, if properly installed, maintained and operated under normal conditions. Donaldson warrants all other Donaldson built components and accessories including Donaldson Airlocks, TBI Fans, TRB Fans, Fume Collector products and Donaldson built Afterfilters for twelve (12) months from date of shipment.
Need help?
Do you have a question about the E-100 and is the answer not in the manual?
Questions and answers