Configuration Example For Client-Initiated L2Tp Tunnel - HP VSR1000 Layer 2 - Wan Access Configuration Manual

Verifying the configuration
# After the dial-up connection is established, the remote system can obtain an IP address (for
example, 192.168.0.2) and can ping the private IP address of the LNS (192.168.0.1).
# On the LNS, use the display l2tp tunnel command to check the established L2TP tunnels.
[LNS] display l2tp tunnel
LocalTID RemoteTID State
1
# On the LNS, use the display l2tp session command to check the established L2TP sessions.
[LNS] display l2tp session
LocalSID
1

Configuration example for client-initiated L2TP tunnel

Network requirements
As shown in
network. The PPP user belongs to VPN 1.
Figure 17 Network diagram
Configuration procedure
1. Configure the LNS:
# Configure IP addresses for the interfaces. (Details not shown.)
# Create VPN instance vpn1, and bind interface Ethernet 1/1 (connecting the PPP user) to vpn1.
<LNS> system-view
[LNS] ip vpn-instance vpn1
[LNS-vpn-instance-vpn1] quit
[LNS] interface ethernet 1/1
[LNS-Ethernet1/1] ip binding vpn-instance vpn1
[LNS-Ethernet1/1] quit
# Configure the route between the LNS and the remote host. (Details not shown.)
# Create a local user named vpdnuser, set the password, and enable the PPP service.
[LNS] local-user vpdnuser class network
[LNS-luser-network-vpdnuser] password simple Hello
[LNS-luser-network-vpdnuser] service-type ppp
[LNS-luser-network-vpdnuser] quit
# Configure local authentication for PPP users in ISP domain system.
[LNS] domain system
[LNS-isp-system] authentication ppp local
1 Established
RemoteSID
1
Figure 17, a PPP user directly initiates a tunneling request to the LNS to access the corporate
Sessions RemoteAddress
1 1.1.2.1
LocalTID State
1 Established
27
RemotePort RemoteName
1701 LNS