B+B SmartWorx SEG510-2SFP-T User Manual page 51

Table 50: PoE (Continued)
Function
system ac-disconnect
(enable|disable)
system overload-discon-
nect (port-priority|over-
load-port-first)
interfaces IF_NMLPORT
legacy-mode
(enable|disable)
interfaces IF_NMLPORT
state (enable|disable)
interfaces IF_NMLPORT
plfc (enable|disable)
interfaces IF_NMLPORT
priority
(low|medium|high|criti-
cal)
interfaces IF_NMLPORT
power-limit <0-30000>
Privilege Description
Admin EXEC Use ac-disconnect com-
mand to determine which
disconnect type will be
selected.
Admin EXEC Use system overload-dis-
connect command to deter-
mine which PoE port will
supply power when the total
power is at full load.
There are two algorithms
supported, and this com-
mand allows selection of
the algorithm.
Admin EXEC Use "legacy-mode
(enable|disable)" command
to configure supply power
mechanism to legacy mode
in PoE port.
Admin EXEC Use "state (enable|dis-
able)" command to config-
ure whether PoE port will
supply power or not.
Admin EXEC Use "plfc (enable|disable)"
command to configure how
much power PoE port will
supply based on PD's class
level.
Admin EXEC Use "priority
(low|medium|high|critical)"
command to configure PoE
port's priority of power sup-
ply sequence.
Admin EXEC Use "power-limit <0-
30000>" command to con-
figure how much power can
be used via PoE port.
44
CLI
Example
This example shows how to
configure disconnect type to
DC typeswitch(config-poe)#.
system ac-disconnect disable
This example shows how to
select overload-port-first to be
the overload-disconnect's algo-
rithm.
switch(config-poe)# system
overload-disconnect overload-
port-first
This example shows how to
configure fa1's PoE power to
legacy mode.
switch(config-poe)# interfaces
FastEthernet 1 legacy-mode
enable
This example shows how to
stop PoE port supply power via
fa1.
switch(config-poe)# interfaces
FastEthernet 1 state disable
This example shows how to
configure fa1's PoE supply
power mode to plfc(power-limit
from class).
switch(config-poe)# interfaces
FastEthernet 1 plfc enable
This example shows how to
configure fa1 as the most high
priority level in power supply
sequence.
switch(config-poe)# interfaces
FastEthernet 1 priority critical
This example shows how PoE
configure fa1's power of POE
to 15W.
switch(config-poe)# interfaces
FastEthernet 1 power-limit
15000