B+B SmartWorx SEG510-2SFP-T User Manual page 22

Table 15: LLDP (Continued)
Function
show lldp interfaces
IF_NMLPORTS neigh-
bor
show lldp statistics
show lldp interfaces
IF_NMLPORTS statis-
tics
show lldp interfaces
IF_NMLPORTS tlvs-
overloading
clear lldp statistics
[no] lldp
[no] lldp tx
[no] lldp rx
lldp holdtime-multiplier
<2-10>
no lldp holdtime-multi-
plier
lldp tx-interval <5-
32767>
no lldp tx-interval
lldp reinit-delay <1-10>
no lldp reinit-delay
lldp tx-delay <1-8191>
no lldp tx-delay
lldp tlv-select pvid
(enable|disable)
Privilege Description
User EXEC Display the neighbor's
LLDP information in speci-
fied ports.
User EXEC Display the LLDP RX/TX
statistics.
User EXEC Display the LLDP RX/TX
statistics in specified ports.
User EXEC Display the length of LLDP
TLVs and if the TLVs over-
load the PDU length in
specified ports.
Admin EXEC Clear statistics of LLDP.
Admin EXEC Disable or enable LLDP.
Admin EXEC Per port disable or enable
LLDP TX.
Admin EXEC Per port disable or enable
LLDP RX.
Admin EXEC Set the LLDP PDU hold
multiplier that decides time-
to-live (TTL) value sent in
LLDP advertisements: TTL
= (tx-interval * holdtime-
multiplier).
Admin EXEC
Admin EXEC Set the LLDP TX interval.
Admin EXEC
Admin EXEC Set the LLDP re-initial
delay. This delay avoids
LLDP generating too many
PDUs if the port is up and
down frequently.
Admin EXEC
Admin EXEC Set the delay in seconds
between successive LLDP
frame transmissions. The
delay starts to count any
time that LLDP PDU is sent,
such as by LLDP PDU
advertise routine, LLDP
PDU content change, port
link up, etc.
Admin EXEC
Admin EXEC This command per port
configures the 802.1 PVID
TLV attach enable status.
15
CLI
Example
switch# show lldp interfaces
fa5,fa6 neighbor
switch# show lldp statistics
switch# show lldp interfaces
fa5,fa6 statistics
switch# show lldp interfaces
fa5,fa6 tlvs-overloading
switch# clear lldp statistics
switch(config)# lldp
switch(config-if)# lldp rx
switch(config-if)# lldp tx
switch(config)# lldp holdtime-
multiplier 4
switch(config)# no lldp hold-
time-multiplier
switch(config)# lldp tx-interval
30
switch(config)# no lldp tx-inter-
val
switch(config)# lldp reinit-delay
2
switch(config)# no lldp reinit-
delay
switch(config)# lldp tx-delay 2
switch(config)# no lldp tx-delay
switch(config-if)# lldp tlv-select
pvid enable