B+B SmartWorx SEG510-2SFP-T User Manual page 14

Table 8: Spanning Tree (Continued)
Function
no spanning-tree hello-
time
spanning-tree forward-
delay <4-30>
no spanning-tree for-
ward-delay
spanning-tree maxi-
mum-age <6-40>
no spanning-tree maxi-
mum-age
spanning-tree tx-hold-
count <1-10>
no spanning-tree tx-
hold-count
spanning-tree pathcost
method (long|short)
[no] spanning-tree
spanning-tree port-prior-
ity <0-240>
no spanning-tree port-
priority
Privilege Description
Admin EXEC Restore to default hello-
time. Default hello-time is 2.
Admin EXEC Specify the forward-delay
interval (seconds).
Admin EXEC Restore to default forward-
delay. Default forward-delay
is 15.
Admin EXEC Specify the maximum-age
time (seconds).
Admin EXEC Restore to default maxi-
mum-age. Default maxi-
mum-age is 20.
Admin EXEC Specify the tx-hold-count
value.
Admin EXEC Restore to default tx-hold-
count. Default tx-hold-count
is 6.
Admin EXEC Specify the type of pathcost
value as 32 bits (long).
Specify the type of pathcost
value as 16 bits (short).
Admin EXEC Enable or Disable Span-
ning-Tree Protocol per port.
Admin EXEC Specify the STP port prior-
ity; must use multiples of
16.
Admin EXEC Restore to default port-pri-
ority. Default port-priority is
128.
7
CLI
Example
switch# configure
switch(config)# no spanning-
tree hello-time
switch(config)# exit
switch# configure
switch(config)# spanning-tree
forward-delay 30
switch(config)# exit
switch# configure
switch(config)# no spanning-
tree forward-delay
switch(config)# exit
switch# configure
switch(config)# spanning-tree
maximum-age 10
switch(config)# exit
switch# configure
switch(config)# no spanning-
tree maximum-age
switch(config)# exit
switch# configure
switch(config)# spanning-tree
tx-hold-count 10
switch(config)# exit
switch# configure
switch(config)# no spanning-
tree tx-hold-count
switch(config)# exit
switch# configure
switch(config)# spanning-tree
pathcost method short
switch(config)# exit
switch# configure
switch(config)# interface gi1
switch(config-if)# spanning-
tree
switch(config-if)# exit
switch(config)# exit
switch# configure
switch(config)# interface gi1
switch(config-if)# spanning-
tree port-priority 64
switch(config-if)# exit
switch(config)# exit
switch# configure
switch(config)# interface gi1
switch(config-if)# no spanning-
tree port-priority
switch(config-if)# exit
switch(config)# exit