Iridium EDGE User Manual page 50

double sided tape which may cause the tape to inadvertently adhere the Iridium Edge to the
mounting surface.

The installer needs to provide all mounting hardware for the Screw Mounting installation. Screw
selection is installation specific depending on the mounting surface thickness and its material
type.

The Accessory Bag contents are not required for the Side Mount installation. These can be set
aside.

Use Iridium Edge to carefully mark the mounting holes.

Drill four (4mm) holes in the mounting surface and/or the bracket that secures the Iridium Edge.

Select a side channel for the cable to exit, depending on cable routing and installation restrictions.

Remove the grey plug from the selected channel by gently prying it out with a sharp flat head
screwdriver. If the plug needs to be re-inserted, ensure the plug is flat to the baseplate before
pressing in with your thumb. Do not use any instruments to re-insert. Optionally remove the
second grey plug as it is provided for aesthetic purposes only.

Firmly press the pigtail cable into the selected channel, making sure that the cable is flush with
the baseplate. Do not use any sharp instruments.

In the event that the pigtail cable must be removed from the side channels, always keep a thumb
over the center of the Iridium Edge where the pigtail connector exits. It is very important to be
careful with the pigtail cable when it is not secured in the side channel.

If the supplied aesthetic grey plug is not used, optionally fill the unused channel with silicon
sealant to prevent the insertion of sharp tools under Iridium Edge.

Insert mounting screws and tighten the screws and nuts. Do not exceed torque over 40 N-m.
50