Mounting The Control Tower; Installing The Threaded Shaft; Initial Start-Up - Ranger DST-1000 Installation And Operation Manual

4. Slide the hood assembly over the bracket axle then
secure in place using the 3/8" allen bolt and washer.
5. Raise the hood and hold it up. Use help to hold the hood
while attaching the hood spring.
Attaching the spring without holding the hood in place may
cause it to snap open suddenly, resulting in personal injury.
6. Hook the other end of the spring over the pin to the rear
of the mounting bracket. Make sure the spring fits into the
grove in the pin.
7. Connect the hood switch wires together as shown.

MOUNTING THE CONTROL TOWER

1. Locate the control tower assembly and remove the
assembly hardware from the parts box.
2. Using help, carefully hold the control tower above the
mounting area on the left side of the cabinet assembly.
3. Locate the wire ribbon coming out of the bottom of the
control tower as well as the wire ribbon near the opening of
the cabinet.
4. Carefully connect the wire ribbons together making sure
the snap connector is tightly fastened. (Note: The snap
connector may be installed one way only. Do not force
together. If the snap connector does not connect easily, flip
a connector over and try again.)
INSTALLING THE
THREADED MAIN SHAFT
1. Locate the Threaded Main Shaft and mounting bolt in
the accessory box and install as shown. Be sure to tighten
the bolt firmly.

INITIAL START-UP

1. Turn the balancer ON/OFF switch to ON.
2. A "beep" will be heard three times then the display will
light up.
3. Press START button. The threaded main shaft should
spin CLOCKWISE when viewed straight on. If the faceplate
spins counterclockwise, turn the balancer off and consult
the factory.
7