Table of Contents
Advertisement
PARAMETER SETTINGS
BE CAREFUL: The following instructions are to view and/or
reset the factory parameter settings only. If not followed
correctly the balancer will malfunction and/or instruct you to
put weights at locations that may cause improper balance.
These parameter settings are pre-set at the factory and
should only be adjusted for special circumstances.
IMPORTANT NOTE:
Before performing the following procedures make sure the
shaft and centering cones are clean and undamaged.
Even the slightest dirt or damage can cause inaccurate
readings. PAY CLOSE ATTENTION to the following
procedures. If not followed correctly, the balancer
will not perform accurately.
1. Turn on the power then select a standard 16" steel wheel
and mount correctly. ( Refer to pages 10-11. )
2. Enter the correct wheel data. ( Refer to page 12. )
3. Press the FUN button to DY setting.
dis SETTING
1. Press the CAL button ( and hold ) then the START button.
Hold both simultaneously for six seconds. The display screen
will flash momentarily then display CAL -- CAL .
2. Next, press these buttons one at a time in the following
order. It is not necessary to hold each button.
"A"
"A"
FIRST
SECOND
d.s. - xxx
3. At this time
panel. ( xxx represents data already entered. Actual
numbers may vary. ) NOTE: If d.s. - xxx is not displayed,
try again pressing the buttons more rapidly.
THIRD
will be shown on the display
dis
4.To adjust the
buttons.
5. Proceed directly to the
procedures below.
in-I SETTING
1. After first checking or properly adjusting the
press the "A" Up button.
in. - xxx
2. At this time
panel. ( xxx represents data already entered. Actual
numbers may vary. )
in-I
3.To adjust the
setting use the "B" Up or Down buttons.
IMPORTANT NOTE:
in-I
The
setting uses
continually rotate "around the clock" using the "B" Up or
in. - xxx /
in. + xxx /
SFA SETTING
1. After first checking or properly adjusting the
press the "A" Up button.
SFA. - xxx
2. At this time
panel. ( xxx represents data already entered. Actual
numbers may vary. )
SFA
3.To adjust the
setting use the "B" Up or Down buttons.
STORING THE DATA
1. Press the "A" Up button TWICE to return to Wheel Data
settings. Double check wheel data entries then proceed
directly to the CALIBRATION procedure and complete.
( Refer to page 9 )
15
setting, use the "B" Up or Down
in-I
setting by following the
dis
will be shown on the display
+
-
or
readings. The numbers
Down buttons.
EXAMPLE
Negative Number Setting
Positive Number Setting
in-I
will be shown on the display
setting,
setting,
Hide quick links:
Advertisement
Table of Contents
