Table of Contents
Advertisement
WHEEL DATA KEY BOARD
a - Wheel Offset
This is the distance between the side of the balancer and
the inner edge of the wheel. To enter Wheel Offset data
refer to the instructions below.
1. Turn the machine on.
2. Press the
button adjacent to
-a-
3.
will be displayed in the INNER window.
4. Pull the index arm out from the side of the machine until the
tip touches the inner edge of the wheel.
5. Read the offset measurement as displayed on the scale
directly on top of the index arm. Press the corresponding
buttons adjacent to
.
to enter the correct data.
b - Wheel Width
This is the width of the wheel at the inner edges. This
distance is measured with the calipers. To enter Wheel
Width data refer to the instructions below.
1. Position the calipers over the wheel and touch the tips
against the wheel edges.
2. Read the measurement shown on the calipers.
3. Press the
button adjacent to
-b-
4.
will be displayed in the INNER window.
5. Press the corresponding
data. IMPORTANT NOTE: The standard setting for this
operation is shown in INCHES. If metric is desired, new
calipers with metric readings will have to replace the
calipers that accompanied the unit. (See page 10 for
changing "b" reading to MM or INCH setting.)
"d" - Wheel Diameter
This is the diameter of the wheel at the rim flanges. This
measurement can be read on the tire sidewall. To enter
Wheel Diameter data, refer to the instructions below.
1. Read the diameter of the wheel as shown on the tire
sidewall.
2. Press the
button adjacent to
-d-
3.
will be displayed in the INNER window.
4. Press the corresponding
correct data. (See page 10 for changing "d" reading to
MM or INCH setting.)
12
.
buttons to enter the correct
.
buttons to enter the
Hide quick links:
Advertisement
Table of Contents
