Gram / Ounce Selection; Mm / Inch Selection; Mounting Wheels; Rear Cone Mounting - Ranger DST-1000 Installation And Operation Manual

GRAM / OUNCE SELECTION

This machine is capable of registering GRAM or OUNCE
readings. The setting for either GRAM or OUNCE will be
displayed on the panel screen just below the INNER and
OUTER windows. When the balancer is set to register
OUNCE readings, OZ. will be lighted on the display. When
the balancer is set to register GRAM readings, OZ. will be no
longer be lighted. (NOTE: GR. will not be lighted with the
GRAM reading selected.) To select either GRAM or OUNCE
settings, follow the procedures below.
1. First press the STOP button then both the
adjacent to . HOLD ALL THREE simultaneously
for three seconds.
2. Remove your finger FIRST FROM THE STOP BUTTON
then the buttons.
3. Your selection will then appear on the display and the
weight readings will change in the INNER and OUTER
windows to register the applicable setting.

MM / INCH SELECTION

"b" SETTING / WHEEL WIDTH
To select either MM or INCH measurement reading for the
"b" WHEEL WIDTH setting, follow the procedures below.
1. Press the or button adjacent to
-b- in the INNER window.
2. Press the STOP then
simultaneously. Your selection readings will now appear in
the "b" SETTING display.
MM / INCH SELECTION
"d" SETTING / WHEEL DIAMETER
To select either MM or INCH measurement reading for the
"d" WHEEL DIAMETER setting, follow the procedures
below.
1. Press the or button adjacent to
-d- in the INNER window.
2. Press the STOP then
simultaneously. Your selection readings will now appear in
the "d" SETTING display.
buttons
to display
button adjacent to
to display
button adjacent to

MOUNTING WHEELS

Select the most appropriate mounting method for the wheel
you are balancing. Using the proper method ensures secure
mounting, accurate displays and safe balancer operation. It
also prevents damage to the wheel. On most wheels, the
inner side of the wheel hub usually has the most uniform
surface for wheel balancing. Always center the wheel by the
most uniformly shaped side of the hub to achieve the most
accurate balance.
Regardless of mounting type, always make sure that the
wheel is forced firmly against the arbor faceplate and that
the hub nut engages the threaded arbor for at least four
complete turns. To assist in centering the wheel properly,
rotate the wheel on the arbor while tightening the hub nut.

Rear Cone Mounting

Most original equipment and steel wheels can be mounted
properly using this method. The wheel is centered on a
cone from the inner side of the hub.
1. Place the cone spring on the arbor with the large end
towards the balancer.
2. Select the cone that best fits the center hole in the wheel.
Slide the cone onto the arbor with the large end towards the
spring.
3. Lift the wheel onto the arbor and center it on the cone.
4. Attach the pressure cup to the hub nut and spin the
assembly onto the arbor. Tighten securely.
10