Spin Mode / Dynamic, Al1, Al3, Al4; Spin Mode / Static - Ranger DST-1000 Installation And Operation Manual

Spin Mode / DYNAMIC, AL1, AL3, AL4

1. Once the correct wheel data and FUNCTION have been
programmed, lower the hood to begin the spin mode.
Before initiating the spin sequence, make sure that the
hub nut is secure and engaged on the arbor threads by
at least four (4) full turns.
2. After the hood is lowered, or the START button is
depressed, the wheel will spin for approximately six
onds then stop automatically.
3. After the wheel stops, weight readings for each side of the
wheel (INNER and OUTER) will appear in the center display
screen.
4. Turn the wheel by hand until the weight position indicator
lights on the side marked INNER are FULLY ILLUMINATED.
This indicates the position specified by the balancer for the
inner weight position.
5. Attach the specified weight for the INNER position at
top-dead-center. NOTE: To hold the wheel in position when
installing weights, press down on the SHAFT RESTRAINT
PEDAL located on the right side of the machine.
All weight positions are located at TOP-DEAD-CENTER.
The more accurate you are in selecting the exact weight
and position, the more accurate the wheel will be
balanced.
NOTE:
6. After the INNER weight is properly installed, turn the
wheel by hand until the weight position indicator lights on
the side marked OUTER are fully illuminated. This
indicates the position specified by the balancer for the
OUTER weight position.
sec-
7. Attach the specified weight for the CENTER PLANE
position at top-dead-center.
1. Once the correct wheel data has been programmed,
lower the hood to begin the spin mode.
2. After the hood is lowered, or the START button is
depressed, the wheel will spin for approximately six
seconds then stop automatically.
3. After the wheel stops, weight readings will appear in the
center display screen.
4. Turn the wheel by hand until the weight position indicator
lights on the side marked INNER are fully illuminated. This
indicates the position specified by the balancer for the inner
weight position.
5. Attach the specified weight for the INNER PLANE at top-
dead-center.
6. After the INNER weight is properly installed, turn the
wheel by hand until the weight position indicator lights on
the side marked OUTER are FULLY ILLUMINATED. This
indicates the position specified by the balancer for the
CENTER PLANE weight position.
7. Attach the specified weight for the CENTER PLANE
position at top-dead-center.
STATIC balancing is not an accurate method of balancing and
should be used only when the customer request no
weights on the outer edges or plane of the wheel.
1. Once the correct wheel data has been programmed,
lower the hood to begin the spin mode.
13
Spin Mode / AL2

Spin Mode / STATIC

visible