Table of Contents
Advertisement
FIGURE 3 – NBN READY FOR
TRANSITION TO BROADBAND
SERVICE ONLY (FTTB OR FTTN)
This configuration applies if you have an existing working ADSL broadband service and
you want it to work with your new HNG device before the changeover to the NBN.
1. Connect your HNG as shown in the figure below. Then follow the instructions under
'Step-by-Step Guide to Installing the HNG' on page 6.
2. To avoid interference and performance degradation, the HNG must be connected
to the main telephone socket in your premises on its own, with all other internal cabling
and existing telecommunications equipment disconnected (e.g. facsimile and security
alarms). If required, a qualified licensed cable installer or electrician can re-connect
your internal in-home cabling.
3. If you want your new HNG to operate with your existing ADSL broadband service, you
will need to have the user ID and password details for your existing ADSL broadband
service. If you need assistance, contact your Service Provider.
4. After the changeover to the NBN, your new broadband service will operate directly from the HNG.
Your old ADSL broadband service will now no longer be active.
5. The filter is now no longer required so you can now connect your HNG DSL port directly to the
main telephone socket, using the same grey phone cable.
11
Hide quick links:
Advertisement
Table of Contents
