Camera Administration - Digitus DN-16100-2 Quick Start Manual

3. Plug an Ethernet cable into Video Server
Connect an Ethernet cable to the LAN socket located on the device's panel and attach it to the
network.
4. Connect RS485 (option)
When users would like to apply a camera with P/T/Z function, they usually need to connect their
communication port (for camera control) through RS485. After RS-485 was correctly connected to
D+ and D-, the remote users could control the camera movement through Internet.
5. Connect an external power supply to Video Server
Connect an external power supply to the 12VDC power jack of the Video Server. Once you have
installed the Video Server well, the Power LED (orange) will turn on later. It means the system is
booting up successfully. Furthermore, if you have a proper network connection, and access to the
Video Server, the LAN LED (green) will flash.
6. Connect DC power to one external camera from Video Server (option)
In case your Video Server is connected to PoE switch, then this device can provide 12VDC out to
supply one external camera thru 12VDC power jack. Note that the output current is 300mA
maximum.
7. Done

3. Camera administration

When you installed your networked device over your network environment, to start Network
Camera web configuration, you must have the web browsers installed on computer for web
management.
-
Microsoft internet Explorer 6.0 or higher
At first, user may use "IP Wizard II" utility to search all networked devices in the LAN.
Use "IP Wizard II" to locate IP address
Press "Search" button. IP Wizard II will list all networked devices in the LAN:
5