Main Motor Unit; Removal Of Led Lamp Assy - Brother 888X62 Series Service Manual

Basic of Disassembly
1

Removal of LED lamp assy

1. Remove the two screws (taptite, bind S M4x10) to remove the two cord clamps from the arm bed, and
remove the two cord clamps from the lead wire of LED lamp assy.
2. Disconnect the connector of LED lamp assy from the PCB of motor 3P supply assy.
Motor 3P supply assy
Connector of LED lamp assy
3. Remove the screw (screw, pan (S/P washer) M4x8) to remove the LED lamp assy from the base holder
assy.

Main motor unit

Taptite, bind S M4x10
PCB
Base holder assy
2 - 10
LED lamp assy
Cord clamp
LED lamp assy
Screw, pan (S/P washer) M4x8
Taptite, Bind S M4X10
Arm bed
Screw, Pan (S/P washer) M4X8