Brother 888X62 Series Service Manual page 53

Adjustment
<From previous page>
8. Turn the pattern selecting dial until the left needle position straight stitch is the topmost position.
9. Turn the pulley by hand and lower the needle bar until the needle point comes near the paper.
Pulley
10. Loosen the screw of the pattern select unit assy.
11. Insert a flat screwdriver into the notch part of the plate, and move the plate by turning a flat screwdriver, and move
the needle point left and right. And adjust them so that the pinhole on paper matches up with the needle point.
*Key point
• Turn a flat screwdriver to the direction "a".  Move the needle point to right side.
• Turn a flat screwdriver to the direction "b".  Move the needle point to left side.
12. Tighten the screw of the pattern select unit assy.
*Key point
• Need to adjust "3-9 Needle interference left/right"
Left straight stitch needle drop and
zigzag stitch maximum left needle drop position
Pattern selecting
dial
Screw
b
a
Flat screwdriver
3 - 16
b
Match up a pinhole with the needle point.
after this adjustment.
Needle bar
Paper
Screw M3X8
Hex wrench
2.5 mm
Needle
a