Installing And Removing The Battery; Battery Charging - Xplore DT-07 User Manual

Installing and Removing the Battery

Installing the Battery
1. Align the battery metal contacts with the contact pins inside the battery
compartment.
2. Press the battery down until the battery lock clicks into place.
3. Ensure the battery cover lock is in unlock position. Align the battery cover with the
battery compartment; and push the battery cover down.
4. Slide left the battery cover lock to lock the cover.
Removing the Battery
Note: Always power off the device before removing the battery.
1. Slide the battery cover lock left until the battery cover ejects slightly.
2. Remove the battery cover.
3. Slide the battery lock down and hold it at the unlocked position.
4. Lift the battery from the battery compartment.

Battery Charging

Charging the Device
1. Connect the AC/DC adaptor to the DC jack of the cradle.
2. Plug the AC/DC adaptor into a suitable power socket. The cradle power LED will
turn green when power is supplied to the cradle.
3. Insert the device to the cradle slot. The device LED will indicate red while charging,
and then it will turn green when fully charged.
Charging the Spare Battery
1. Align the battery metal contacts with the contact plates of the battery slot.
2.
Slide the battery down the battery slot until the battery clicks into place. The cradle
battery LED will turn red while charging, and then it will turn green when fully
charged.
9