Outer Drum, Chain, And Sprocket Removal - Honda GL 1000 Shop Manual

7. Flex the frame next to the lower
mounting bolt (approximately
2
mm) to facilitate removal of the
front oil screen cover securing
screw.
8. Remove the oil screen cover.
9. Remove the oil screen.
10. Slowly pour approximately 1
quart of clean oil into the crank-
case oil filler to flush any clutch
particles toward the oil screen.
11.
Reach into the oil screen cavity
and scoop out any loose particles
as the oil is being poured into the
engine.
12.
Reassemble and adjust the clutch.
13. I nstall and tighten the drain plug.
14.
Clean and install the oil screen.
15. Install the oil screen cover.
16.
Replace the front oil screen cover
screw with a hex head bolt
approximately
3
mm shorter
than the original securing screw
to facilitate future removal and
installation.of the oil screen cover.
17. Retorque the lowerel1gine
mounting bolt to
550
to
650
kg-em (40-47 ft-Ib).
1 Install the muffler and head pipe.
19. Fill crankcase with new engine
oil.
20.
Runthe for approximately
5
minutes.
21.
Remove and replace the oil filter.
22.
Repeat steps
2, 3, 5, 8,9, 13, 14,
15, 18
and
19.
OUTER DRUM
Ofl
SCAVENGE
PUMP DRIVE CHAIN
AND SPROCKET
t
l!dl')!}o:=31 REAR ENGINE
COVER BOLTS
REAR ENGINE COVER
"\
Outer Drum, Chain, and Sprocket
Removal
NOTE
Removal of these parts requires that
engine be removed from the
as described in Section 4.
10-10
GL·1000 SHOP MANUAL
1976 American Honda
in U.S.A. 7·78
Co., Inc.