Advertisement
4
Sun-3/260 Hardware Installation Manual
1.4. Unpacking the
Pedestal
NOTE
a
The 12-slot 31260 has a shipping weight of about 100 pounds. This will
vary, depending on the number of boards shipped with the product. Two
people will be needed to unpack and set up the pedestal.
The bottom of the shipping carton is the side touching the pallet The front of the
shipping carton is the side facing the front of the pedestal (the front of the pede-
stal has a dark grey bezel). Left and Right are referenced by looking at the ship-
ping carton from the front.
1.
When unpacking the pedestal, carefully preserve and save the shipping
materials for future use.
2.
Cut the fiber banding that secures the pedestal's shipping carton to the pal-
let.
3.
Remove the pedestal shipping carton from the pallet (keeping the carton in
an upright position).
4.
Remove the carton's top cover.
5.
Lift out both the triangular box containing the pedestal's stabilizing wings
.J
and the square box containing the pedestal's external cables.
6.
Lift up and away on the left side of the pedestal's shipping carton.
7.
Tilt the right side of the shipping carton away from the pedestal to a 45°
angle. Lift the right side away from the carton.
8.
Unfold the right side of the bottom of the shipping carton, and lay the
unfolded side flat on the floor.
9.
Unfold the back side of the bottom of the shipping carton, and lay the
unfolded side flat on the floor.
10. Lift up on the rear of the pedestal to clear the wheels from the foam, and
remove the rear foam block. Set the rear of the pedestal down.
11. Lift up on the front of the pedestal and remove the front foam block. Set the
front of the pedestal down onto its wheels, and roll the pedestal to the
desired location.
To ·repack the pedestal into its shipping carton, reverse the steps used to unpack
it Remember to unfold the carton bottom's right and back sides before rolling
the pedestal back into the carton.
Revision A of 10 October 1986
Advertisement
