Initial Connection - Wav; Verify The Installation - Neptune Apex WAV Quick Start Manual

an AquaBus address and be added to the Apex configuration. The LED Status indicator on the 1LINK will flash
while it is being initialized. This takes a second or two. Once initialized, the LED Status indicator will be solid
green. The LED Status indicator will flash green if communication with the Apex Base Unit is lost.

INITIAL CONNECTION - WAV

Connect the WAVs only after the 1LINK has been successfully connected and the status LED is lit solid green.
There are three numbered 1LINK ports; connect each WAV to any of the three.

VERIFY THE INSTALLATION

Verify the 1LINK and WAVs were initialized and added to the Apex configuration:
Apex Display: Setup –> Module Setup –> Modify Name – from this screen, you can see all AquaBus
modules installed on the system.
Classic Apex Web Interface: Configuration –> Module Setup – Verify the 1LINK is listed in the Apex
Module List and note the module number assigned to it.
There will be two programmable outlets automatically created when you connect the 1LINK to your Apex
system. They will be called LINKA_X_1 and LINKB_X_2 where 'X' is the module number automatically
assigned to your 1LINK. These outlets correspond to the 24VDC ACC ports on the 1LINK; they are for use
with Neptune Systems accessory products; they will not be used for your WAV installation.
There will also be a single outlet created for each connected WAV, named WAV_#_1; each WAV will have a
unique AquaBus address.
You should also see a FLO tile on the APEX Fusion dashboard.
dashboard. If you do not see the LINKA, LINKB, and WAV outlet tiles on the classic dashboard or the LINKA,
LINKB, and WAV outlet tiles and the FLO tile on the APEX Fusion dashboard, check the respective unused tiles
area.
WAV QuickStart Guide
There will not be a FLO tile on the classic
Page 4