Neptune Apex WAV Quick Start Manual page 4

Assembling the WAV pump
1. Unpack a WAV pump and magnetic mount set.
2. Carefully separate the two halves of the magnetic mount. Retain the packing material used as a
spacer between the magnets for future use.
3. Set aside the outer magnet.
4. Pick up a WAV, and hold it upright (with the cable at the top)
a. Note that the inner magnet assembly has a center channel with 3 round bumps and 1
rectangular ridge.
b. In your other hand, pick up the inner magnet and hold it as shown in the image below, with
the rectangular ridge at the bottom.
c. Starting with the inner magnet below the pump, slide the inner magnet upward onto the track
on the back side of the WAV pump.
WAV QuickStart Guide
The ridge is near the bottom of the inner mount.
Page 2