Wav Monitoring And Alerts - Neptune Apex WAV Quick Start Manual

WAV MONITORING AND ALERTS

The WAV has the capability to report various abnormal conditions; there are 4 types of WAV alarms:
Position Error Alarm – The WAV can sense if its position has been changed, such as might happen if the
pump gets solidly bumped during maintenance, or if someone has removed the outer magnet mount and the
pump has fallen to the bottom of the tank.
Stall Alarm – The WAV can sense a stall condition which might be caused by sand in the pump or by an
obstruction blocking propeller movement.
Voltage Alarm – the WAV can detect and report a low or high voltage condition with the 24VDC input power.
Temperature Alarm – the WAV can sense and report a high internal temperature.
These alarms may be individually enabled or disabled for each WAV through the Classic Dashboard
Configuration->Module Setup page. All four are enabled by default.
After initial installation of a WAV and anytime the position of the WAV is changed, the pump's base or home
position should be reset using the Set Home Position button as seen in the image below. After the Home
Position is set, any significant change in the position of the WAV will trigger a Position Alarm error (if the
Position Alarm option is enabled).
NOTE: Before setting the Home Position of each of your WAVs, the WAV outlet(s) must be turned OFF.
WAV QuickStart Guide Page 8