Advertisement
A set of four M8 inserts on the top, designed to be used with the Peavey® Versamount™ 70+ mounting bracket.
Group D
A set of four M8 inserts on the right side, designed to be used with the Peavey Versamount 70+ mounting
bracket.
Group E
A set of four M8 inserts on the bottom, designed to be used with the Peavey Versamount 70+ mounting brack-
et.
For Group A and B, always use both inserts as a pair; NEVER use just one insert to fly a cabinet!
For Group C, D and E, Always use all four inserts of a given group as a set; NEVER use just one insert to fly a
cabinet! The four insert groupings are meant to have all four inserts used at once within a group.
Group E should only be used with the Versamount 70+ oriented beneath the cabinet, and at an angle less than
30 degrees from vertical.
SPECIFICATIONS FOR INSERT MATING HARDWARE
Group A and Group B should use an M10 forged steel shoulder-type lifting eyebolt, which meets the require-
ments of DIN 580 or ASTM A489. They should only be used in pairs, and in conjunction with the rear most
pair of M8 inserts on the same surface as a pull-back/aiming adjustment, using M8 eyebolts of a similar spec-
ification. The length of the threaded shank on the eyebolts should not exceed 3/4" (approx. 20 mm), so that it
does not bottom-out in the insert. Thread pitch: 1.5 mm per thread.
Group C and D should use an M8, grade 8.8 or better, 1.25 mm per thread, metric bolt, that does not penetrate
the cabinet beyond the cabinet surface more than 3/4 " (approx. 20 mm). When using a Peavey Versamount
70+ mounting bracket and lock washer, the length of the bolt should not exceed 1.125" (approx. 30 mm).
Group E should use an M8, grade 8.8 or better, 1.25 mm per thread, metric bolt, that does not penetrate the
cabinet beyond the cabinet surface more than 0.472" (12 mm). When using a Peavey Versamount 70+ mount-
ing bracket and lock washer, the length of the bolt should not exceed 3/4" (approx. 20 mm).
WARNING! (note to structural engineer)
The thread insertion depth past the surface of the cabinet of the end of the mounting bolt should not be more
than 0.787" (20 mm) for insert groups A, B, C and D, and not more than 0.472" (12 mm) for Group E.
If these thread insertion depths are exceeded, then the inserts may be damaged or unseated from the cabinet,
severely compromising the mounting integrity of the cabinet!
For maximum mounting strength, safety and reliability, the bolt threads should engage at least 10 mm of depth
for Group A and B, and at least 8 mm of depth for groups C, D and E.
The PVXp™ 12 DSP mounting insert groups C, D and E are designed to be used with the Peavey Versamount
70 Plus mounting bracket (00454470 black, 00454460 white), as well as the Impulse® 12" array bracket
(00386920 black, 00386940 white). It can also be used with the Peavey Wall-Mount Speaker Stand (00922940
black, 00487390 white), which will fit into the built-in stand mount cup on the bottom of the cabinet.
Advertisement
