Specifications; Battery Charging - Globus Genesy 500 User Manual

Denervated Muscles :
Channels available
Maximum intensity
Impulses
Iontophoresis :
Channels available
Constant current
Minimum intensity
Maximum intensity
Minimum time
Maximum time

Specifications

Batteries
Power supply
Exterior
Protection level
Size
Weight
Certifications

BATTERY CHARGING

The Globus Electrostimulator is furnished with a set of rechargeable nickel-metal hydrate bat-
teries , which have high yield without "memory effect". Recharge the batteries when the bat-
tery light on the display ( ) indicates ¼.
To charge the batteries, turn off the electrostimulator and detach the electrodes. Attach the
supplied battery charger by inserting the plug in the appropriate inlet on the electrostimulator
(figure). The LED on the charger lights when the connection is correctly made. The first time
the batteries are charged, be sure not to interrupt the process until complete, about 10 hours.
If the electrostimulator is connected for longer periods (but not greater than 72 h), the batte-
ries will not be damaged.
Do not use battery chargers other than the one supplied. To replace the electrostimulator's
batteries, contact an authorized service center.
Attention:
- While the batteries are being charged, the electrostimulator must not be connected to the
electrodes.
- If the battery charger is connected to the electrostimulator when the instrument is on, it will
turn off automatically.
- If the battery charger, the electrical cord or the connector show signs of wear or damage,
replace immediately.
Channels 1, 3
60 mA
Triangular, 1000 ms
Rectangular-trapezoidal, 500 ms
Channel 1
Yes
0 mA, 1000 Ohm
10 mA, 1000 Ohm; 0.1 mA, 1000 Ohm steps
1 min
99 min
Rechargeable Ni-MH accumulator, 7.2 V, 1.5 Ah
Globus model
Modello Globus
Acrylonitrile butadiene styrene (ABS), food-contact
grade
IP 20
160 mm x 99 mm x 35.4 mm
404 gr
EU Medical Device Directive (MDD, 93/42/EEC)
ILD 41070200
MB072C015UK
110 V
REV. 03.09.04
ILD 41V 0720200
230 V 230 V
9