Hardware Installation; Connecting The Device - Motorola MG7550 User Manual

Do not press the Reset button unless you want to clear the current settings. The
Reset button is in a small circular hole on the rear panel. If you want to restore the
default settings, please press the Reset button gently for 5 second with a fine needle
inserted into the hole and then release the button. The system reboots and returns to
the factory defaults.
3.2

Hardware Installation

3.2.1 Connecting the Device

Please follow the steps below to connect the device.
Step1 Connect the Cable port of the CM/RG with HFC cable.
Step2 Connect the Eth port of the CM/RG to the network card of the PC via an
Ethernet cable.
Step3 Plug one end of the power adapter to the wall outlet and connect the
other end to the Power port of the CM/RG.
MG7550 Cable Modem User Manual
6