JVC VF-P116U Service Manual page 4

5. Remove the CRT socket
Ó
Fig. 1-6
6. Shortcircuit the anode of the CRT to the chassis or the FBT
cover for discharge, and then disconnect the anode plug
Note: The anodic electrode is located inside the rubber
cover of the anode plug
careful not to get an electric shock.
6
7. Loosen one screw fixing the CRT to the deflection yoke
and remove the soldering
Pull the CRT out of the deflection yoke in the direction of the
arrow (f).
ˆ
Fig. 1-7
When reassembling the CRT to the set, put the spring
onto the pin on the bottom cover without fail.
Ô
Fig. 1-8
2
˝
.
˝
Ó
. When discharging, be
ˆ
.
6
Ó
.
1.3 REMOVAL OF MAIN BOARD
1. Open the bottom cover referring to "1.1 REMOVAL OF
COVER".
2. Remove four screws
tached.
7
Ô
Fig. 1-9
7
and the MAIN board can be de-
Fig. 1-10
PIN
7