Reset (Totalizer) - Sigma 980 Operating And Maintenance Manual

Section 4

4.3.1.2 Reset (Totalizer)

Note: The mechanical totalizer
cannot be reset manually.
Note: If any type of condition
occurs, both the resettable and the
non-resettable totalizers are reset.
The resettable totalizer can be used
to total flow over a finite period and
can be reset as often as desired
without affecting the other totalizers.
Page 72
Mechanical Totalizer
3. Set the Totalizer Scaling factor using the CHANGE CHOICE soft key. All
three totalizers are scaled with one of seven scaling factors: X1, X10,
X100, X1000, X10,000, X100,000 or X1,000,000. The selected scaling
factor always applies to all totalizers. Press the
to cycle through the available scaling choices.
4. Press the soft key to continue.
ACCEPT
5. Set the Total Flow Units using the CHANGE CHOICE soft key to cycle
through the choices. Total Flow Units are independent of the flow units
selected in the Setup Menu. Flow units of measure include:
• Acre-feet
• Cubic Feet
6. Press the soft key to continue.
ACCEPT
The non-resettable totalizer will only be reset if one of the following
conditions occur:
• Change in totalizer scaling
• Change in totalizer units of
measure
1. Select from the
RESET
will appear.
2. Press the soft key to reset the totalizer or press the
YES
reset the totalizer.
To reset both software totalizers at once, start a program with the
key.
RUN/STOP
View Totals
To view the current totals of both the resettable and non-resettable totalizers,
press from the Totalizer menu. Both totalizer values will appear.
VIEW TOTALS
CHANGE CHOICE
• Liters •
• Cubic Meters
• Change in primary device
• Start of new program
menu. A confirmation message
TOTALIZER
soft key
Gallons
soft key to not
NO