Section 3 Basic Programming Setup; Initial Power-Up Of Meter; Basic Programming; Step 1 - Setup - Sigma 980 Operating And Maintenance Manual

Section 3

3.1 Initial Power-Up of Meter

3.2 Basic Programming

Note: To make changes to the
program entries after the basic
programming setup, press the
MAIN MENU key and select
SETUP>MODIFY SELECTED
ITEMS. Highlight the program
entry using the up and down arrow
soft keys.

Step 1 - Setup

Basic Programming Setup
After power is applied, the flow meter performs a complete diagnostic self-test
and displays the menu shown when the unit was last turned off. Set the
instrument programming features when the Main Menu is displayed. The Main
Menu is the starting point for all programming operations. The Main Menu
offers four choices:
• Setup—Basic programming
• Status—Lists all currently measured readings
• Display Data—Shows graphs and tables of logged data
(See Displaying Data on page
• Options—Advanced programming
Setup and Options functions lead to sub-menus and will configure the basic
and advanced features of the flow meter. Refer to the
Chart on page 149. The Display Data and Status lead to sub-menus and will
provide information only. Press the
channels that have enabled logging (flow, pH, temp., etc.).
11:00 AM 21 - APR - 01
DISPLAY DATA
OPTIONS
READY TO START
Basic programming setup must be performed, in its entirety, after the
instrument is installed. Refer to the
Flow Chart on page 150 for more information. The basic program setup will
modify all items:
• Flow Units
• Primary Devices
• Program Lock
• Sampler Pacing
1-A. Press the soft key from the Main Menu to prepare the 980 Flow
SETUP
Meter for use.
1-B. Press the
MODIFY ALL ITEMS
begin setting up the flow units.
117)
Main Program Flow
soft key to display any data
STATUS
980 Flow Meter Basic Programming Setup
• Site ID
• Velocity Direction
• Velocity Units
• Velocity Cutoff/Velocity Default
soft key and press the
ACCEPT
Basic Programming Setup
* Main Menu*
SETUP
STATUS
soft key to
Page 59