Window Menu; Help Menu - Decagon Devices EM50 Operator's Manual

4 SOFTWARE & CONFIGURATION
lular carriers are available within the range of the Em50G logger.
Use the Configure Radio Modem to change the channel and sub-
channel for your Em50R or DataStation.
The Device Tools submenu contains several items.
The "Test Device Firmware" option determines if you have any
firmware (the internal software that runs the Em50) errors. To
initiate a firmware test, select Actions
vice Firmware. This automatically tests the integrity of your Em50
firmware, and report if it reads as Bad or Good.
The "Initialize Radio Module" option resets the radio module to the
default setting. This option applies to Em50Rs and DataStations
only.
The "Initialize Device" option initiates a form of hard reset for your
Em50. ECH20 Utility resets your Em50 and re-writes all the logger
settings. All your measurement data is erased. This option is useful
for troubleshooting a logger that is not working as expected.
Note: Initializing your Em50 deletes all stored data. Make sure any
data has been downloaded out of the Em50 before initiating a reset.
4.3.5

Window Menu

The Window menu contains the "Show Terminal" command. The
terminal window allows you to directly enter commands for your
Em50, and is mainly used for troubleshooting and diagnosis.
4.3.6

Help Menu

The Help menu allows access to the ECH20 Utility help file, allows
you to check for program and firmware updates, and displays infor-
mation about your copy of the ECH20 Utility.
Device Tools
32
Em50 Series
Test De-