VTL S-400 II series Owner's Manual page 63

Reset stored bias values (during standby mode only) with retube by holding down BIAS and RESET
buttons for 15 seconds until clear response (--) from display.
•
Temperature display (Operate mode only): Press TEMP/RESET button to show temperature for 2
seconds. (In degrees Celsius or Fahrenheit.)
Resets:
•
Tube time (Standby mode only): Reset with retube by holding down TUBE TIME and RESET buttons
for 15 seconds until clear response (--) from display.
•
Service reminder (Operate mode only): Reset by holding down TUBE TIME and RESET for 5
seconds until TUBE green led bar and TUBE TIME on 7 seg display turns off.
•
TUBE LIFE (Standby mode only) Clear tube fault stored value by holding down the TUBE LIFE
button and the RESET button for 15 seconds until clear signal (--) received from 7 seg display.
•
Stored Bias Values (Standby mode only): Reset with retube by holding down BIAS and RESET buttons for
15 seconds until clear response (--) from display.
S-400 Amplifier Owner's Manual
VTL
59