Yamaha Clavinova Owner's Manual page 37

3 Use a vinyl tie to take up any slack in the pedal cord.
4 Insert the plug of the power cord into the power connector.
6
Set the adjuster.
Rotate the adjuster until it comes in firm contact with the
floor surface.
7
Attach the headphone hanger.
Use L (x 2) to attach the hanger as shown in the
illustration.
L
8
Attach F to A.
1 Finger-tighten J (x 2) as shown in the illustration.
1
J
A
Approx. 5 mm
2 Install the brackets of F onto J, and slide them so that J fit into
the smaller ends of the keyhole slots.
F
2
A
F
A
3
3 Fully tighten J.
After completing the assembly, please check the following.
• Are there any parts left over?
→ Review the assembly procedure and correct any errors.
• Is the instrument clear of doors and other movable
fixtures?
→ Move the instrument to an appropriate location.
• Do the instrument or the music rest make a rattling
noise when you shake it?
→ Tighten all screws.
• Does the pedal box rattle or give way when you step on
the pedals?
→ Turn the adjuster so that it is set firmly against the floor.
• Are the pedal and power cords inserted securely into
the sockets?
→ Check the connection.
CSP-170/CSP-150 Owner's Manual
37