Section 2. General Information; Introduction; Description; Section 3. Jva Mounting Positions - Jandy JVA 2444 Pro Series Installation And Operation Manual

Jandy

Section 2. General Information

2.1

Introduction

This manual contains information for the proper
installation and operation of Jandy
Actuators (JVA). Procedures in this manual must be
followed exactly. To obtain additional copies of this
manual visit www.zodiacpoolsystems.com. For address
information, see back cover.
2.2

Description

Valve Actuators are designed to meet the needs of
today's more advanced, automatic pool equipment.
These fully adjustable actuators offer versatile pool/spa
automation with easy setups. All actuators work with
AquaLink RS Control Systems and are available in 24
®
volt units.
JVA 2444 Specifications
Voltage 24 VAC
Amperage 0.75 AMPS
Cycles 60 Hz
Wire 3-conductor
Black Common
Red Switch Leg
White Switch Leg
|
Pro Series Valve Actuator Installation and Operation Manual
®
Pro Series Valve
®
Section 3. JVA Mounting
Positions
3.1

Standard JVA Position

Standard Plumbing position is with the middle port
(B) as the incoming or common port to the valve (see
Figure 1).
A
Water flow into or
B (Common Port)
out of the valve
Figure 1. Standard Plumbing
Standard Mounting position is with the main body of
the actuator over port B (see Figure 2).
NOTE
If the valve(s) are plumbed with port B as the
common port (Standard Plumbing) and the main
body of the actuator(s) are mounted over port B
(Standard Mounting), there is no need to adjust the
actuator cams.
A
Figure 2. Standard JVA Mounting
ENGLISH Page 5
Remove these
four (4) screws for
Standard Position
C
C
B (Common Port)