Main Parts - ONNLINE ESSENSSE Instruction Manual

2. UNPACKING
2.1 CHECK THE DELIVERY
DO NOT MISS!
Check immediately after delivery that the packed product
has not been damaged. If the packaging is damaged inform
the carrier. If the complaint is not lodged in time, no future
demands can be claimed.
Check that the product type is the same as you ordered. In
•
the case of an irregularity do not unpack the air curtain and
immediately report the fault to the supplier.
After unpacking, check that the air curtain and other parts
•
are in order. If in doubt contact the supplier.
Never install a damaged air curtain!
•
If you are not going to unpack the air curtain immediately
•
after delivery, it must be stored in a dry indoor environment
with an ambient temperature between +5 °C and +40 °C.
All used packaging materials are ecologi-
cal and can be reused or recycled. Active-
ly contribute to the protection of the en-
vironment by properly disposing of and
recycling packaging materials.

3. MAIN PARTS

1
Mounting brackets
2
Top cover
3
Area for connecting the regulation module
4
Suction cover
5
Connection for water heat exchanger (only on water versions)
6
Side cover (attached magnetically)
+40 C
o
+5 C
o
6
2.2 CONTENTS
1x
4x M6x20
DO NOT MISS!
In the event that the ventilation unit was transported in a
•
temperature lower than 0 °C, it is necessary to leave the
unit for at least 2 hours without turning it on, allowing the
temperature inside the unit to be levelled to the tempera-
ture of the surrounding area.
1
5
2x
2x
VCE-x-xxx-V only
2
3
4
5