Step 4: Setting The Speakers' Channels; Advance Bass Management; Movie Mode; Music Mode - Philips DVP9000S User Manual

Step 4: Setting the speakers'
channels
You can adjust the delay times (centre
and surround only) and volume level for
individual speakers. These adjustments let
you optimize the sound according to
your surroundings and setup.
IMPORTANT!
The speaker settings only available on
Multi-channel audio outputs. You can
also press SOUND MODE button to
select Multi-channel.
1
Press SYSTEM MENU.
2
Press 4 to select {SETUP}.
3
Press 1 2 to highlight {SPEAKERS}, then
press 4.
Speakers
Setup
Front Size
Centre Size
Surround Size
Subwoofer
Use or to select other options,
RETURN to leave the menu.
4
Press 34 to highlight one of the options,
then press 2.
{FRONT SIZE, CENTER SIZE,
SURROUND SIZE}
OFF – when no speaker is connected.
LARGE – when connected speakers can
produce low frequency signals below
120Hz.
SMALL – when connected speakers
cannot produce low frequency signals
below 120Hz.
{SUBWOOFER}
ON – when a subwoofer is connected.
OFF – when no subwoofer is connected.
To return to the previous menu, press 1.
TIPS:
To remove the menu, press
01-41 DVP900_00A31

Movie Mode

Music Mode

to enter the submenu,
SYSTEM MENU
21
Getting Started
{FRONT DISTANCE}
– Sets the distance from your listening
place to the front speakers (1 ~ 11.8m).
{CENTER/REAR DISTANCE}
– Sets the distance from your listening
place to the center/rear speakers. (choices
different depending on the {FRONT
DISTANCE} setting).
5
Press 1 2 3 4 to adjust the setting that
best suit your surround sound needs.
6
Press OK to confirm.
Helpful Hints:
– Use the longer delay time settings when
the surround/rear speakers are closer to the
listener than the front speakers.

Advance Bass Management

Movie Mode
This menu allows you to adjust each
speaker volume for playing all discs
except SACD audio playback.
The volume balance value ranges from
-6dB to +7dB.
Music Mode
When music mode is set, speaker settings
will be applied during SACD playback
only.
Additional adjustments available in SACD
bass managements are:
– Cut-off frequency adjustment:
60Hz, 80Hz, 100Hz and 120Hz
– Slope adjustment:
12dB/oct, 18dB/oct and 24dB/oct
Helpful Hint:
– These additional adjustments are
available in the subwoofer adjustments.
.
/00_3139 246 13873
13/01/2005, 09:58
21