Cleaning; Power Cord Maintenance; Troubleshooting; Spare Parts - Ikra LSN 2600 E Operating Instructions Manual

CLEANING

- Take debris bag down and clear leaves in joints of
debris bag by using the brush (Fig. Q)
- Move the zipper and pour grass out (Fig. R1)
- Don't empty debris bag with hands - risk of injury (Fig.
R2).
- Take the Impeller Guard down and clear leaves in the
Impeller by using the brush (Fig. S1).
- Use the brush to clear leaves in the mouth of blower
tube (Fig. S2)
- Clear the surface of housing (Fig. S3,S4)

Power Cord Maintenance

If the supply cord needs replacing, the task must be car-
ried out by the manufacturer, the manufacturer's agent,
or an authorised service centre in order to avoid a safety
hazard.

Troubleshooting

Attention! Always remove the plug from the
mains socket before starting any work on the
machine.
The machine won't start: Check whether the switch
•
is in the "ON" position; check that the residual current
circuit breaker is not switched off and that no fuses
have blown in its electric circuit. If the machine still
won't start have it inspected by an authorised cus-
tomer service firm.
• The machine won't vacuum: Check whether the
leaf collection bag is full, otherwise have the machine
inspected by an authorised customer service firm.
• The machine won't blow: Have the machine in-
spected by an authorised customer service firm.
• The shredder wheel is blocked: Check whether an
object has been sucked in that is too large; a piece of
wood, cardboard or other object has become jammed
between the impeller and shredder chamber. If the
shredder wheel remains blocked have the machine
inspected by an authorised customer service firm.
• If the machine vibrates, please immediately stop us-
ing it. Have the machine inspected by an authorised
customer service firm.

Spare parts

Collection bag # 74800128

Waste disposal and environmental protection

In accordance with European Directive 2012/19/EC on
waste electrical and electronic equipment and its im-
plementation in national law, waste electric tools must
be collected separately for environmentally-compatible
re-use.
Recycling alternative to the return invitation:
Instead of returning the electric equipment, the owner is
alternatively obligated to take part in the proper recycling
in the case of relinquishment of ownership. The waste
equipment can also be taken to a collection facility which
disposes of it in the sense of the national recycling ma-
nagement and waste acts. This does not pertain to the
accessory parts and auxiliary equipment without elec-
trical components accompanying the waste equipment.

Warranty

For this electric tool, the company provides the end user
- independently from the retailer's obligations resulting
from the purchasing contract - with the following war-
ranties:
The warranty period is 24 months beginning from the
hand-over of the device which has to be proved by the
original purchasing document. For commercial use and
use for rent, the warranty period is reduced to 12 months.
Wearing parts and defects caused by the use of not fitting
accessories, repair with parts that are no original parts
of the manufacturer, use of force, strokes and breaking
as well as mischievous overloading of the motor are
excluded from this warranty. Warranty replacement does
only include defective parts, not complete devices. War-
ranty repair shall exclusively be carried out by authorized
service partners or by the company's customer service.
In the case of any intervention of not authorized person-
nel, the warranty will be held void.
All postage or delivery costs as well as any other subse-
quent expenses will be borne by the customer.
GB-9