Hyundai i10 Owner's Manual page 38

B210A01NF/H/Q
To release the seat belt:
The seat belt is released by pressing the
release button (1) in the locking buckle.
When it is released, the belt should auto-
matically draw back into the retractor.
If this does not happen, check the belt to
be sure it is not twisted, then try again.
Pre-tensioner seat belt
(if equipped)
Your vehicle is equipped with driver's and
front passenger's pre-tensioner seat
belts (retractor pretensioner and EFD
(Emergency Fastening Device)). The pre-
tensioner seat belts can be activated,
where the frontal collision is severe
enough, together with the air bags.
When the vehicle stops suddenly, or if
the occupant tries to lean forward too
quickly, the seat belt retractor will lock
into position. In certain frontal collisions,
the pre-tensioner will activate and pull
the seat belt into tighter contact against
the occupant's body.
Safety system of your vehicle
(1) Retractor Pretensioner
The purpose of the retractor preten-
sioner is to make sure that the shoul-
der belts fit in tightly against the occu-
pant's upper body in certain frontal
collisions.
(2) EFD (Emergency Fastening Device)
The purpose of the EFD is to make
sure that the pelvis belts fit in tightly
against the occupant's lower body in
certain frontal collisions. (if equipped,
Driver only)
OMG035300
If the system senses excessive tension on
the driver or passenger's seat belt when
the pre-tensioner system activates, the
load limiter inside the retractor pre-ten-
sioner will release some of the pressure
on the affected seat belt. (if equipped)
3 19