Hyundai i10 Owner's Manual page 172

WINDSHIELD DEFROSTING AND DEFOGGING
WARNING
- Windshield
heating
Do not use the or
during cooling operation in extreme-
ly humid weather. The difference
between the temperature of the out-
side air and the windshield could
cause the outer surface of the wind-
shield to fog up, causing loss of vis-
ibility. In this case, set the mode
selection knob or button to the
position and fan speed control knob
or button to the lower speed.
• For maximum defrosting, set the tem-
perature control to the extreme
right/hot position and the fan speed
control to the highest speed.
• If warm air to the floor is desired while
defrosting or defogging, set the mode
to the floor-defrost position.
• Before driving, clear all snow and ice
from the windshield, rear window, out-
side rear view mirrors, and all side win-
dows.
• Clear all snow and ice from the hood
and air inlet in the cowl grill to improve
heater and defroster efficiency and to
reduce the probability of fogging up
inside of the windshield.
■ Left-hand drive
• Type A
position
■ Right-hand drive
• Type A
Manual climate control system
To defog inside windshield
1. Select any fan speed except "0" position.
2. Select desired temperature.
3. Select the
4. The outside (fresh) air and air conditioning (if equipped) will be selected auto-
matically.
If the air-conditioning (if equipped) and outside (fresh) air position are not select-
ed automatically, press the corresponding button manually.
• Type B
• Type B
OBA04316/OIA043171L/OBA043169L/OIA043171
position.
Features of your vehicle
4 95